8 x 10 x 6.5mm BRASS Shim spacer - Slips on the Motor Axle to align Motor Pulley

This little BRASS Spacer is precision made. It slips on the Motor Axle positioning the Motor Pulley in the perfect place. It is made from Brass & it will not rust on you!

The spacer slips onto the Axle, fitting before the Motor Pulley. Should there be any tollerance or if you have not quite positionied your motor in the right place use a0,5mm Shim to help position your self more so... You want the belt running in harmony on the motor & Slave pulley....

This tiny spacer positions the wheel perfectly on the axle, holding the Bearing in the best possible place to help achieve maximum spin rate for the bearing & wheel. Its little parts like these that suffer the most amount of abuse, especially when they are used in the harsh conditions that they are. Check from time to time they are in good order & possibly replacing them every now & then this good practice will ensure your board stays in tip-top condition, always!