M5 x 20mm Complete Deck Bolt Kit - This complete Bolt kit fixes the TRUCKS & BINDINGS to 11ply TRAMPA Decks. All TRAMPA Bolts are dipped in BLUE LOCKING PASTE whilst all of the nuts have been fitted with the world renowned "Nylock" locking system to ensure the most secure fix possible!
Use 2 x 8mm spanners to turn the M5 Truck Nut from/onto the M5 Truck Bolt & use a 4mm Allen key to hold the M6x25 Countersunk Binding Bolt & a 10mm spanner to tighten the M6 nut from/onto the M6 bolt.
Always ensure all the Nuts & Bolts are nice & tight all the way around your board before you ride!
The following are required to build this product:
This 25mm Marine Grade Stainless Steel Complete Deck Bolt kit fixes the TRUCKS & BINDINGS to all ply 15º TRAMPA ATB Decks.
All of TRAMPAs Bolts are dipped in BLUE LOCKING PASTE whilst all of the Nuts have been fitted with the world renowned "Nylock" locking system to ensure the most secure fix possible! & being made of Marine Grade Stainless Steel our fixings will never rust on you
To assemble your Board with this kit you will need
2 x 8mm Spanners
1 x 10mm Spanner
1 x 4mm Allen Key
Firstly place the washers onto the Bolts & then push the M5 Hex Head Truck bolts through the Deck holes into & out of the truck below. Using your fingers keep the connection tight & tighten the M5 nut onto the bolt. Repeat this placing all 8 x M5 Bolts into the deck (Both ends) finger tightening their nuts on. To tighten the truck bolts use the 8mm Spanners & hold the Truck nut with one spanner & tighten the M5 Bolts evenly with the other. When everything is evenly tight go round all of the nuts & bolts & Turn them all tight so you dont get any loose wobbles...
To fit the bindings, push the Countersunk bolts from the underside of the deck and place the Ladderstap L-Brackets into the outside position on the deck. Slip the Washers over the top of the L-Bracket & then finger tigthen the M6 nuts onto the bolts. Then place footstraps on top of the inner countersunk bolts and repeat finger fixing. Use the 4mm Allen Key and hold the bolt steady from the underside, using the 10mm spanner tighten the M6 nut down onto the L-Bracket... Always ensure all the Nuts & Bolts are nice & tight all the way around your board before you ride!
In this kit you get :